AT-9000 Switch Command Line User’s Guide
Section X: Network Management 941
NO LLDP MED-TLV-SELECT
Syntax
no lldp med-tlv-select capabilities|network-
policy|location|power-management-ext|inventory-
management|all
Parameters
all Configures a port to stop sending all LLDP-MED
TLVs.
capabilities Specifies the capabilities TLV.
network-policy Specifies the network policy TLV.
location Specifies the location identification TLV.
power-management-ext Specifies the extended power-via-MDI TLV. (This
TLV does not apply to the AT-9000 Switches.)
inventory-management Specifies the inventory management TLV.
Mode
Port Interface mode
Description
Use this command to stop ports from transmitting LLDP-MED TLVs. You
can specify just one TLV per command. The default setting is for ports to
send all optional LLDP-MED TLVs, except for the inventory TLV.
Confirmation Command
“SHOW LLDP INTERFACE” on page 951
Examples
This example stops port 8 from transmitting all LLDP-MED TLVs:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.8
awplus(config-if)# no lldp med-tlv-select all
To Next Page
Loading...
