Allied Telesis AT-9000/28 - Show Location; Table 98. SHOW LLDP STATISTICS INTERFACE Command

AT-9000 Switch Command Line User’s Guide
Section X: Network Management 965
SHOW LOCATION
Syntax
show location civic-location|coord-location|elin-location
[identifier
id-number |interface port ]
Parameters
id-numberI Specifies an ID number of a location entry.
port Specifies a port. You can specify more than one port.
Mode
User Exec mode and Privileged Exec mode
Description
Use this command to display the civic, coordinate and ELIN location
entries on the switch. Here is an example of a civic location entry.
Figure 159. SHOW LOCATION Command for a Civic Location
The information the command displays is explained in Table 98.
Examples
This example displays all the civic location entries on the switch:
ID Element Type Element Value
------------------------------------------------
8 Country US
State CA
City San-Jose
Street Suffix Avenue
Postal Code 95132
Building 1020
Primary Road Name Pineapple
Table 98. SHOW LLDP STATISTICS INTERFACE Command
Column Description
ID The ID number of the entry.
Element Type A parameter of the entry.
Element Value The current value of a parameter.