Allied Telesis AT-9000/28 - Displaying the ARP Table

Chapter 63: Address Resolution Protocol (ARP)
972 Section X: Network Management
Displaying the ARP Table
To display the ARP table, use the SHOW ARP command in the User Exec
mode or the Privileged Exec mode:
awplus# show arp
Here is an example of the table.
Figure 160. SHOW ARP Command
The window is described in Table 100 on page 978.
IP ARP
ARP Cache Timeout ......... 300 seconds
Total ARP Entries ......... 215
IP Address MAC Address Interface Port Type
-----------------------------------------------------------------
149.122.34.4 0006.5BB2.4421 vlan2-0 port1.0.2 Dynamic
149.122.34.12 00A0.D218.EEA1 vlan2-0 port1.0.3 Dynamic
149.122.34.21 00A0.C357.3214 vlan2-0 port1.0.4 Dynamic
149.122.35.1 00A0.64B1.76A5 vlan8-0 port1.0.7 Dynamic