Allied Telesis AT-9000 Series - Page 1020

Chapter 65: SNMPv1 and SNMPv2c Commands
1020
“SHOW SNMP-SERVER VIEW” on
page 1033
Privileged Exec Displays the SNMP views.
“SNMP-SERVER” on page 1034 Global
Configuration
Enables SNMPv1 and SNMPv2c on
the switch.
“SNMP-SERVER COMMUNITY” on
page 1035
Global
Configuration
Creates new SNMPv1 and SNMPv2c
community strings.
“SNMP-SERVER ENABLE TRAP” on
page 1036
Global
Configuration
Activates the transmission of all
SNMP traps, except for link status and
authentication traps, which are
activated separately.
“SNMP-SERVER ENABLE TRAP
AUTH” on page 1037
Global
Configuration
Activates the transmission of SNMP
authentication traps.
“SNMP-SERVER HOST” on
page 1038
Global
Configuration
Adds the IP addresses of trap and
informs receivers to the community
strings on the switch.
“SNMP-SERVER VIEW” on
page 1040
Global
Configuration
Creates SNMP views.
“SNMP TRAP LINK-STATUS” on
page 1042
Port Interface Configures SNMP to transmit link
status notifications when ports
establish links or lose links to network
devices.
Table 89. SNMPv1 and SNMPv2c Commands (Continued)
Command Mode Description