Allied Telesis AT-9000 Series - No Snmp Trap Link-Status

Chapter 65: SNMPv1 and SNMPv2c Commands
1028
NO SNMP TRAP LINK-STATUS
Syntax
no snmp trap link-status
Parameters
None
Mode
Port Interface mode
Description
Use this command to disable the transmission of SNMP link status
notifications (traps) when ports establish links (linkUp) or lose links
(linkDown) to network devices.
Confirmation Command
“SHOW INTERFACE” on page 221
Example
This example disables the transmission of link status notifications on ports
17 and 21:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.17,port1.0.21
awplus(config-if)# no snmp trap link-status