AT-9000 Switch Command Line User’s Guide
1103
Here are the commands to configure the ports to send the TLVs:
awplus> enable
Enter the Privileged Executive
mode from the User Executive
mode.
awplus# configure terminal
Enter the Global Configuration
mode.
awplus(config)# interface port1.0.18,port1.0.24
Enter the Port Interface mode for
ports 18 and 24.
awplus(config-if)# lldp transmit receive
Configure the ports to accept and
send TLVs to and from their
neighbors.
awplus(config-if)# no lldp tlv-select all
Remove all optional LLDP TLVs
from the ports with the NO LLDP
TLV-SELECT command.
awplus(config-if)# no lldp med-tlv-select all
Remove all optional LLDP-MED
TLVs from the ports with the NO
LLDP MED-TLV-SELECT
command.
awplus(config-if)# lldp tlv-select port-
description
awplus(config-if)# lldp tlv-select link-
aggregation
awplus(config-if)# lldp tlv-select mac-phy-config
Add the optional TLVs you want
the ports to transmit, with the
LLDP TLV-SELECT command.
awplus(config-if)# end
Return to the Privileged Exec
Mode.
awplus# show lldp interface port1.0.18,port1.0.24
Use the SHOW LLDP
INTERFACE command to confirm
the configuration.
To Next Page
Loading...
