AT-9000 Switch Command Line User’s Guide
1135
LLDP MED-NOTIFICATIONS
Syntax
lldp med-notifications
Parameters
None
Mode
Port Interface mode
Description
Use this command to configure the switch to send LLDP-MED topology
change notifications when devices are connected to, or disconnected
from, the specified ports. To prevent the switch from transmitting topology
change notifications, refer to “NO LLDP NOTIFICATIONS” on page 1159.
Confirmation Command
“SHOW LLDP INTERFACE” on page 1167
Example
This example configures the switch to send LLDP-MED topology change
notifications whenever devices are connected to, or removed from, ports
11 and 17:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11,port1.0.17
awplus(config-if)# lldp med-notifications
To Next Page
Loading...
