AT-9000 Switch Command Line User’s Guide
1139
LLDP NOTIFICATIONS
Syntax
lldp notifications
Parameters
None
Mode
Port Interface mode
Description
Use this command to configure ports to send LLDP SNMP notifications
(traps). To prevent ports from transmitting LLDP SNMP notifications, refer
to “NO LLDP NOTIFICATIONS” on page 1159.
Confirmation Command
“SHOW LLDP INTERFACE” on page 1167
Example
This example configures ports 2 and 3 to transmit SNMP notifications:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.2,port1.0.3
awplus(config-if)# lldp notifications
To Next Page
Loading...
