AT-9000 Switch Command Line User’s Guide
1165
SHOW LLDP
Syntax
show lldp
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command to display general LLDP settings. Here is an example
of the information.
Figure 186. SHOW LLDP Command
The fields are defined in Table 105.
Table 105. SHOW LLDP Command
Field Description
LLDP Status Whether LLDP is enabled or disabled on
the switch.
Notification Interval Minimum interval between LLDP
notifications.
Tx Timer Interval Transmit interval between regular
transmissions of LLDP advertisements.
LLDP Global Configuration: [Default Values]
LLDP Status ............... Enabled [Disabled]
Notification Interval ..... 5 secs [5]
Tx Timer Interval ......... 30 secs [30]
Hold-time Multiplier ...... 4 [4]
(Computed TTL value ....... 120 secs)
Reinitialization Delay .... 2 secs [2]
Tx Delay .................. 2 secs [2]
Fast Start Count .......... 3 [3]
LLDP Global Status:
Total Neighbor Count ...... 47
Neighbors table last updated 1 hrs 7 mins 6 secs ago
To Next Page
Loading...
