Allied Telesis AT-9000 Series - Show Lldp Local-Info Interface; Figure 188: SHOW LLDP LOCAL-INFO INTERFACE Command

AT-9000 Switch Command Line User’s Guide
1169
SHOW LLDP LOCAL-INFO INTERFACE
Syntax
show lldp local-info [interface port ]
Parameters
port
Specifies a port, You can specify more than one port at a time with
this command. Omitting this parameter displays the LLDP
information for all the ports.
Mode
Privileged Exec mode
Description
Use this command to display the LLDP and LLDP-MED TLVs that the local
ports are actively transmitting to their LLDP-compatible neighbors. Ports
that have not been activated with “LLDP TRANSMIT RECEIVE” on
page 1147 or that have not established links with their LLDP counterparts
cannot be displayed with this command. See Figure 188 and Figure 189
on page 1170.
Figure 188. SHOW LLDP LOCAL-INFO INTERFACE Command
LLDP Local Information:
Chassis ID Type .................. MAC address
Chassis ID ....................... 0015.77d8.4360
Port ID Type ..................... Port component
Port ID .......................... 25
TTL .............................. 120 (secs)
Port Description ................. Port_25
System Name ...................... [zero length]
System Description ............... AT-9000/28
System Capabilities - Supported .. Bridge, Router
- Enabled .... Bridge, Router
Management Addresses ............. 0.0.0.0
Port VLAN ID (PVID) .............. 1
Port & Protocol VLAN - Supported . No
- Enabled ... No
- VIDs ...... 0
VLAN Names ........................ Default_VLAN
Protocol IDs .....................
MAC/PHY Auto-negotiation .......... Supported / Enabled
Advertised Capability ....... 1000BaseTFD, 100BaseTXFD, 100BaseTX,
10BaseTFD, 10BaseT
Operational MAU Type ........ 30 (1000BaseTFD)