Allied Telesis AT-9000 Series - Figure 191: SHOW LLDP NEIGHBORS DETAIL Command (Continued); Table 106. SHOW LLDP NEIGHBORS DETAIL Command

Chapter 70: LLDP and LLDP-MED Commands
1172
Figure 191. SHOW LLDP NEIGHBORS DETAIL Command (continued)
The information is explained in Table 106.
LLDP-MED Device Type ............. Network Connectivity
LLDP-MED Capabilities ............ LLDP-MED Capabilities,
Network Policy,
Location Identification, Inventory
Network Policy ................... 1
Application Type ........... Voice
Frame Format ............... Untagged
VLAN ID .................... 1
Layer 2 Priority ........... 0
DSCP Value ................. 0
Location Identifier .............. [not advertised]
Extended Power Via MDI (PoE) ..... Not Supported
Inventory Information:
Hardware Revision ........... A
Firmware Revision ........... v1.0.0
Software Revision ........... v1.0.0
Serial Number ............... A04161H09020007
Manufacturer Name ........... ATI
Model Name .................. AT-9000/52
Asset ID .................... [not advertised]
Table 106. SHOW LLDP NEIGHBORS DETAIL Command
Parameter Description
Chassis ID Type Type of the chassis ID.
Chassis ID Chassis ID that uniquely identifies the
neighbor.
Port ID Type Type of the port ID.
Port ID Port ID of the neighbor.
TTL Number of seconds that the information
advertised by the neighbor remains valid.
Port Description Port description of the neighbor’s port.
System Name Neighbor’s system name.
System Description A description of the switch, such as the
product name.
System Capabilities
(Supported)
The device’s functions supported by the
switch.