AT-9000 Switch Command Line User’s Guide
1217
NO RMON ALARM
Syntax
no rmon alarm
alarm_id
Parameters
alarm_id
Specifies the ID number of the alarm you want to delete. You can
delete only one alarm at a time. The range is 1 to 65535.
Mode
Global Configuration mode
Description
Use this command to delete alarms from the switch.
Confirmation Command
“SHOW RMON ALARM” on page 1232
Example
This example deletes the alarm with ID 3:
awplus> enable
awplus# configure terminal
awplus(config)# no rmon event 3
To Next Page
Loading...
