Allied Telesis AT-9000 Series - Page 1223

AT-9000 Switch Command Line User’s Guide
1223
Confirmation Command
“SHOW RMON ALARM” on page 1232
Example
This example creates an RMON alarm that monitors ingress multicast
packets (OID 1.3.6.1.2.1.16.1.1.1.7) on a port assigned a statistics group
with the ID number 5. The alarm triggers event ID number 1 if the number
of multicast packets exceeds 10,000 packets per minute or falls below
1,000 packets:
awplus> enable
awplus# configure terminal
awplus(config)# rmon alarm 1 1.3.6.1.2.1.16.1.1.1.7.5
interval 60 delta rising-threshold 10000 event 1 falling-
threshold 1000 event 1
Note
For examples that illustrate how to create all of the components of
RMON alarms, refer to “RMON Alarms” on page 1206.
etherStatsMulticastPkts 1.3.6.1.2.1.16.1.1.1.7.stats_id
etherStatsCRCAlignErrors 1.3.6.1.2.1.16.1.1.1.8.stats_id
etherStatsUndersizePkts 1.3.6.1.2.1.16.1.1.1.9.stats_id
etherStatsOversizePkts 1.3.6.1.2.1.16.1.1.1.10.stats_id
etherStatsFragments 1.3.6.1.2.1.16.1.1.1.11.stats_id
etherStatsJabbers 1.3.6.1.2.1.16.1.1.1.12.stats_id
etherStatsCollisions 1.3.6.1.2.1.16.1.1.1.13.stats_id
etherStatsPkts64Octets 1.3.6.1.2.1.16.1.1.1.14.stats_id
etherStatsPkts65to127Octets 1.3.6.1.2.1.16.1.1.1.15.stats_id
etherStatsPkts128to255Octets 1.3.6.1.2.1.16.1.1.1.16.stats_id
etherStatsPkts256to511Octets 1.3.6.1.2.1.16.1.1.1.17.stats_id
etherStatsPkts512to1023Octets 1.3.6.1.2.1.16.1.1.1.18.stats_id
etherStatsPkts1024to1518Octets 1.3.6.1.2.1.16.1.1.1.19.stats_id
Table 116. MIB Object Names and ID Numbers (Continued)
MIB Name OID Number