Chapter 74: RMON Commands
1226
RMON COLLECTION STATS
Syntax
rmon collection stats
stats_id
[owner
owner
]
Parameters
stats_id
Specifies the ID number of a new statistics group. The range is 1 to
65535.
owner
Specifies an owner of up to 20 alphanumeric characters for the
group. Spaces and special characters are not allowed.
Mode
Port Interface mode
Description
Use this command to create RMON statistics groups on the ports of the
switch. The groups are used to view RMON port statistics from SNMP
workstations on your network and to create RMON alarms.
A port can have only one RMON statistics group, and a group can be
assigned to just one port at a time. The switch supports up to eight groups,
allowing you to monitor up to eight ports at one time.
Confirmation Command
“SHOW RMON STATISTICS” on page 1238
Example
This example adds a statistics group to port 16 and assigns it the ID
number 16:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.16
awplus(config-if)# rmon collection stats 16
To Next Page
Loading...
