Chapter 74: RMON Commands
1228
RMON EVENT LOG TRAP
Syntax
rmon event
event_id
log trap
community_string
[description
description
] [owner
owner
]
Parameters
event_id
Specifies the ID number of a new event. The range is 1 to 65535.
community_string
Specifies the community string assigned the IP addresses of the
network devices that are to receive the trap. You can specify just
one community string. The community string is case sensitive and
must already exist on the switch.
description
Specifies a description of up to 20 alphanumeric characters for the
event. Spaces and special characters are not allowed.
owner
Specifies an owner of up to 20 alphanumeric characters for the
event. Spaces and special characters are not allowed. You must
enter a description to include an owner.
Mode
Global Configuration mode
Description
Use this command to create events for RMON alarms. This type of event
enters a message in the event log and sends an SNMP trap when a rising
or falling threshold of an alarm is crossed. The same event can be
assigned to multiple alarms.
Confirmation Command
“SHOW RMON EVENT” on page 1234.
To Next Page
Loading...
