AT-9000 Switch Command Line User’s Guide
1267
awplus(config)# ipv6 access-list
deny-all-but-one
Creates a Named IPv6 ACL call “deny-all-
but-one-ipv6” and enters the Configuration
IPv6 ACL command mode.
awplus(config-ipv6-acl)# permit
ip host 2001:odb8::a2/64 host
2001:odb8::a5/64
Allows IPv6 address and subnet mask
2001:odb8::a2/64 full access to the
switch.
awplus(config-ipv6-acl)# deny ip
any host 2001:odb8::a5/64
Denies access all IP addresses access to
the switch.
awplus(config-ipv6-acl)# exit Exit the Configuration IPv6 ACL mode
command mode.
awplus(config)# line vty 0 9 Access the LINE VTY mode for lines 0
through 9.
awplus(config-line)# access-
class deny-all-but-one
Assigns deny-all-but-one to VTY lines 0
through 9.
Table 140. Assigning Named IPv4 ACLs to VTY Lines Example (Continued)
Command Description
To Next Page
Loading...
