AT-9000 Switch Command Line User’s Guide
1371
TELNET IPV6
Syntax
telnet ipv6
ipv6_address
[
port
]
Parameters
ipv6_address
Specifies the IPv6 address of a remote device you want to manage
using the Telnet client on the switch. You can specify just one
address.
port
Specifies the protocol port number of the Telnet client. The default
value is 23.
Mode
Privileged Exec mode
Description
Use this command to start Telnet management sessions on network
devices that have IPv6 addresses. You can manage just one remote
device at a time.
This command is available from local and Telnet management
sessions, but not from SSH management sessions.
Example
This example starts a Telnet management session on a network device
that has the IPv6 address 45ac:be45:78::c45:8156:
awplus> enable
awplus# telnet ipv6 45ac:be45:78::c45:8156
To Next Page
Loading...
