Allied Telesis AT-9000 Series - Ip Radius Source-Interface

AT-9000 Switch Command Line User’s Guide
1459
IP RADIUS SOURCE-INTERFACE
Syntax
ip radius source-interface Ipv4 Address | VID
Parameters
Ipv4 Address
Indicates an IPv4 address in the following format:
xxx.xxx.xxx.xxx
VID
Specifies a VLAN ID.
Modes
Global Configuration mode
Description
Use this command to assign the RADIUS source interface to an IPv4
address or VLAN ID. The RADIUS client uses the specified IP address on
every outgoing RADIUS packet.
Use the no version of this command, NO IP RADIUS SOURCE-
INTERFACE, to remove the RADIUS source lP address from the client.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 158
Examples
This example configures the RADIUS source IP address using a VLAN ID:
awplus> enable
awplus# configure terminal
awplus(config)# ip radius source-interface vlan 1
This example configures the RADIUS source IP address with an IPv4
address:
awplus> enable
awplus# configure terminal
awplus(config)# ip radius source-interface 192.168.1.78