Chapter 8: Basic Switch Management Commands
164
Example
This example displays the managers who are logged on to the switch:
awplus# show users
Idle The number of hours, minutes, and
seconds since the manager using the
account entered a command on the
switch. The value is always zero for your
account because you just entered the
SHOW USERS command.
Location The network device from which the
manager is accessing the switch. A
device connected to the Console port is
identified by “ttys0”, while remote Telnet
and SSH devices are identified by their IP
addresses.
Priv The privilege level of the manager
account. Manager accounts with the
privilege level 1 are restricted to the User
Exec mode, while accounts with the level
15 can access all of the command modes.
Table 10. SHOW USERS Command (Continued)
Parameter Description
To Next Page
Loading...
