Allied Telesis AT-9000 Series - Displaying Threshold Limit Settings on Ports; Figure 43: SHOW STORM-CONTROL Command; Figure 44: SHOW STORM-CONTROL Command

Chapter 9: Port Parameters
184
Displaying Threshold Limit Settings on Ports
To display the threshold settings for the ingress packets on the ports, use
the SHOW STORM-CONTROL command in the Privileged Exec mode.
Here is the format:
show storm-control [ port ]
This example of the command displays the broadcast, multicast and dif
levels on ports 18:
awplus# show storm-control port1.0.18
Here is an example of the information the command displays.
Figure 43. SHOW STORM-CONTROL Command
The columns are described in Table 15 on page 227.
If the parameter port is not specified, the command displays the threshold
settings on all the ports on the switch.
If you want to display information on multiple ports at a time, enter:
awplus# show storm-control port1.0.18,port1.0.20,port1.0.21
Here is an example of the information the command displays.
Figure 44. SHOW STORM-CONTROL Command
Port Bcastlevel Mcastlevel Diflevel
port1.0.18 30 100 100
Port Bcastlevel Mcastlevel Diflevel
port1.0.18 30 100 100
Port1.0.20 100 50 100
port1.0.21 100 100 100