Chapter 10: Port Parameter Commands
228
Examples
This command displays the settings of all the ports:
awplus# show interface status
This command displays the settings of ports 17 and 18:
awplus# show interface port1.0.17-port1.0.18 status
Duplex The duplex mode setting of the port. The
setting can be half, full or auto for Auto-
Negotiation. To set the duplex mode, refer
to “DUPLEX” on page 200.
Speed The speed of the port. The settings are
10, 100, or 1000 Mbps, or auto for Auto-
Negotiation.
Type The Ethernet standard of the port.
Table 15. SHOW INTERFACE STATUS Command (Continued)
Parameter Description
To Next Page
Loading...
