Allied Telesis AT-9000 Series - Power-Inline Description

AT-9000 Switch Command Line User’s Guide
267
POWER-INLINE DESCRIPTION
Syntax
power-inline description description
Parameters
description
Specifies a PD description of up to 256 alphanumeric characters.
Spaces and special characters are allowed.
Mode
Port Interface mode
Description
Use this command to add PD descriptions to the ports to make the ports
and PDs easier to identify.
Note
To add a general description to a port, use the DESCRIPTION
command. For more information, see “DESCRIPTION” on page 198.
Confirmation Commands
“SHOW POWER-INLINE” on page 274
“SHOW POWER-INLINE INTERFACE” on page 279
“SHOW POWER-INLINE INTERFACE DETAIL” on page 280
Example
This example adds the PD description “Surveillance Camera5” to port 5:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# power-inline description Surveillance
Camera5