Allied Telesis AT-9000 Series - Show Power-Inline Interface; Figure 62: SHOW POWER-INLINE INTERFACE Command

AT-9000 Switch Command Line User’s Guide
279
SHOW POWER-INLINE INTERFACE
Syntax
show power-inline interface port
Parameter
port
Specifies a port. You can display more than one port at a time.
Mode
Privileged Exec mode
Description
Use this command to display the PoE information on the ports. An
example is shown in Figure 62.
Figure 62. SHOW POWER-INLINE INTERFACE Command
This command displays a subset of the information the SHOW POWER-
INLINE command displays. The fields are described in Table 23 on
page 275.
Example
This example displays PoE information for ports 1 to 4:
awplus# show power-inline interface port1.0.1-port1.0.4
Interface Admin Pri Oper Power Device Class Max(mW)
port1.0.1 Disabled Low Disabled 0 0 15400 [C]
port1.0.2 Enabled High Powered 3840 Phone 1 5000 [U]
port1.0.3 Enabled Crit Powered 6720 AccessPt 2 7000 [C]
port1.0.4 Disabled Low Disabled 0 0 15400 [C]