AT-9000 Switch Command Line User’s Guide
283
SNMP-SERVER ENABLE TRAP POWER-INLINE
Syntax
snmp-server enable trap power-inline
Parameters
None
Mode
Global Configuration mode
Description
Use this command to activate the transmission of the SNMP power-inline
trap. The trap is sent if the power requirements of the switch and PDs
exceed the power limit threshold set with “POWER-INLINE USAGE-
THRESHOLD” on page 272.
Confirmation Command
“SHOW RUNNING-CONFIG SNMP” on page 1029
Example
This example enables the SNMP power-inline trap:
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server enable trap power-inline
To Next Page
Loading...
