Chapter 14: IPv4 and IPv6 Management Address Commands
312
NO IP ADDRESS
Syntax
no ip address
Parameters
None
Mode
VLAN Interface mode
Description
Use this command to delete the current IPv4 management address from
the switch if the address was assigned manually. If a DHCP server
supplied the address, refer to “NO IP ADDRESS DHCP” on page 313.
You must perform this command from the VLAN Interface mode of the
VLAN to which the address is attached.
The switch uses the IPv4 management address to perform the
features listed Table 26 on page 286. If you delete it, the switch will
not support the features unless it also has an IPv6 management
address.
Confirmation Commands
“SHOW IP INTERFACE” on page 317 and “SHOW IP ROUTE” on
page 318
Example
This example removes the static IPv4 management address from the
VLAN with the VID 15:
awplus> enable
awplus# configure terminal
awplus(config)# interface vlan15
awplus(config-if)# no ip address
To Next Page
Loading...
