Allied Telesis AT-9000 Series - Page 329

AT-9000 Switch Command Line User’s Guide
329
awplus# configure terminal
awplus(config)# ip dhcp pool P1
awplus(dhcp-config)# subnet-mask 255.255.255.0
DEFAULT-ROUTER
The command to add a default router to the DHCP pool is DEFAULT-
ROUTER.
Here is the format of the command:
default-router < ip-address >
The IP-ADDRESS parameter is the IPv4 address of the default router, in
dotted decimal notation.
You can use this command multiple times to create a list of default routers
on the client’s subnet.
Use the NO form of this command to remove either the specified default
router, or all default routers, from the DHCP pool.
This example adds a default router with IP address 192.168.1.2 to the pool
P1.
awplus# configure terminal
awplus(config)# ip dhcp pool P1
awplus(dhcp-config)# default-router 192.168.1.2
DNS-SERVER
The command to add a Domain Name System (DNS) server to the DHCP
pool is DNS-SERVER.
Here is the format of the command:
dns-server < ip-address >
The IP-ADDRESS parameter is the IPv4 address of the DNS server, in
dotted decimal notation.
You can use this command multiple times to create a list of DNS name
servers available to the client.
Use the NO form of this command to remove either the specified DNS
server, or all DNS servers, from the DHCP pool.
This example adds a DNS server with the assigned IP address
192.168.1.1 to the pool P1.