AT-9000 Switch Command Line User’s Guide
359
RANGE
Syntax
range <
ip-address
> [<ip-address>]
Parameters
ip-address
IPv4 address range for DHCP clients, in dotted decimal notation.
The first IP address is the low end of the range; the second IP
address is the high end.
Mode
DHCP Configuration
Description
Use this command to add an address range to a DHCP pool. Specify only
one IP address to add an individual IP address to the DHCP pool.
The DHCP server responds to client requests received from the pool’s
network. It assigns IP addresses within the specified range. The IP
address range must be within the network.
You can add multiple address ranges and individual IP addresses for a
DHCP pool by using this command multiple times.
Example
This example adds an address range of 192.168.100.2 to 192.168.100.20
to the pool P1.
awplus# configure terminal
awplus(config)# ip dhcp pool P1
awplus(dhcp-config)# range 192.168.100.2 192.168.100.20
To Next Page
Loading...
