Allied Telesis AT-9000 Series - Show Ip Dhcp Pool; Figure 77: SHOW IP DHCP POOL Command

AT-9000 Switch Command Line User’s Guide
363
SHOW IP DHCP POOL
Syntax
show ip dhcp pool [<address-pool>]
Parameters
address-pool
Name of a DHCP address pool.
Mode
Privileged Exec
Description
Use the SHOW IP DHCP POOL command to display the configuration
details and system usage of all DHCP address pools configured on the
device.
Use the SHOW IP DHCP POOL command with the ADDRESS-POOL
parameter to display configuration details for a specified DHCP pool.
Figure 77 is an example of the information.
Figure 77. SHOW IP DHCP POOL Command
Example
This example displays configuration details for DHCP pool P1.
awplus# show ip dhcp pool P1
Pool P1 :
Total: 8
Leased: 2
Utilization: 25.0 %
network: 192.168.1.0/24
address ranges:
addr: 192.168.1.10 to 192.168.1.18
Host addresses:
addr: 192.168.1.12 MAC addr: 1111.2222.3333
lease <days:hours:minutes:seconds> <1:0:0:0>
subnet mask: 255.255.255.0