Allied Telesis AT-9000 Series - Displaying the SNTP Client; Figure 79: SHOW NTP ASSOCIATIONS Command; Figure 80: SHOW NTP STATUS Command

AT-9000 Switch Command Line User’s Guide
373
Displaying the SNTP Client
To display the settings of the SNTP client on the switch, use the SHOW
NTP ASSOCIATIONS command in the Privileged Exec mode.
awplus# show ntp associations
The following is displayed:
Figure 79. SHOW NTP ASSOCIATIONS Command
The fields are described in Table 33 on page 383.
To learn whether the switch has synchronized its time with the designated
NTP or SNTP server, use the SHOW NTP STATUS command. An
example of the information is shown in Figure 80.
Figure 80. SHOW NTP STATUS Command
SNTP Configuration:
Status ........................ Enabled
Server ........................ 149.134.23.154
UTC Offset .................... +2
Daylight Savings Time (DST) ... Enabled
Clock is synchronized, reference is 149.154.42.190
Clock offset is -5