AT-9000 Switch Command Line User’s Guide
379
NO NTP PEER
Syntax
no ntp server
Parameter
None
Mode
Global Configuration mode
Description
Use this command to deactivate the SNTP client on the switch. When the
client is disabled, the switch does not obtain its date and time from an
SNTP or NTP server the next time it is reset or power cycled.
Confirmation Command
“SHOW NTP ASSOCIATIONS” on page 383
Example
The following example deactivates the SNTP client on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# no ntp peer
To Next Page
Loading...
