AT-9000 Switch Command Line User’s Guide
381
PURGE NTP
Syntax
purge ntp
Parameter
None
Mode
Global Configuration mode
Description
Use this command to disable the SNTP client, delete the IP address of the
SNTP or NTP server, and restore the client settings to the default values.
Confirmation Command
“SHOW NTP ASSOCIATIONS” on page 383
Example
The following example disables the SNTP client, deletes the IP address of
the SNTP or NTP server, and restores the client settings to the default
values:
awplus> enable
awplus# configure terminal
awplus(config)# purge ntp
To Next Page
Loading...
