Chapter 21: Enhanced Stacking
428
awplus# show estack remotelist
Reconfirm the enhanced stacking
ID number of the replacement
member switch.
awplus# configure terminal
Enter the Global Configuration
mode.
awplus(config)# rcommand 3
Use the RCOMMAND command
to start a remote management
session on the replacement
member switch. In this example
the ID number of the switch is 3.
Login: manager
Password: ******
Log on the replacement member
switch.
awplus> enable
Enter the Privileged Exec mode.
awplus(config)# move boot.cfg actSalesE4.cfg Rename the boot.cfg configuration
file to actSalesE4.cfg.
awplus(config)# boot config-file actSalesE4.cfg
Designate the actSalesE4 file as
the active boot configuration file
on the switch.
awplus(config)# exit
Return to the Privileged Exec
mode.
awplus# exit
End your management session of
the replacement member switch to
return the session to the command
switch.
awplus(config)# reboot estack member 3
From the command switch, reboot
the replacement member switch
so that it configures its parameters
with the actSalesE4.cfg
configuration file.
To Next Page
Loading...
