Chapter 22: Enhanced Stacking Commands
444
SHOW ESTACK COMMAND-SWITCH
Syntax
show estack command-switch
Parameters
None
Mode
Privileged Exec mode
Description
Use this command on a member switch in an enhanced stack to display
the enhanced stacking information about the command switch. This
command is equivalent to issuing the SHOW ESTACK command on the
command switch. Figure 88 is an example of the information the
command displays.
Figure 88. SHOW ESTACK COMMAND-SWITCH Command
The fields are described in Table 38 on page 442.
Example
The following example displays the enhanced stacking information about
the command switch:
awplus> enable
awplus# show estack command-switch
Enhanced Stacking mode Member [1]
Management IP address 0.0.0.0
Mac address ECCD.6D4D.6DD5
Model Type AT-9000/52
Version Number AWPLUS 2.4.1.0
To Next Page
Loading...
