AT-9000 Switch Command Line User’s Guide
463
NO MIRROR INTERFACE
Syntax
no mirror interface
source_ports
Parameters
source_ports
Specifies a source port of the port mirror. You can specify more
than one source port at a time in the command.
Mode
Port Interface mode
Description
Use this command to remove source ports from the port mirror or to delete
the port mirror. You should enter this command in the Port Interface mode
of the destination port of the port mirror.
To delete the port mirror and return the destination port to normal
operations, remove all of the source ports from the port mirror.
Confirmation Command
“SHOW MIRROR” on page 464
Example
These commands remove ports 7 and 8 from the port mirror. If these are
the only source ports of the port mirror, the port mirror is deleted and the
destination port, which in this example is port 11, resumes normal network
operations:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11
awplus(config-if)# no mirror interface port1.0.7,port1.0.8
To Next Page
Loading...
