Allied Telesis AT-9000 Series - Ip Igmp Limit; Figure 94: SHOW IP IGMP SNOOPING

AT-9000 Switch Command Line User’s Guide
479
IP IGMP LIMIT
Syntax
ip igmp limit multicastgroups
Parameter
multicastgroups
Specifies the maximum number of multicast addresses the switch
is allowed to learn. The range is 0 to 255 multicast addresses; the
default is 64 addresses.
Mode
Global Configuration mode
Description
Use this command to specify the maximum number of multicast addresses
the switch can learn. If your network has a large number of multicast
groups, you can use this parameter to limit the number of multicast groups
the switch supports.
Confirmation Command
“SHOW IP IGMP SNOOPING” on page 488
Example
This example sets the maximum number of multicast groups on the switch
to 25:
awplus> enable
awplus# configure terminal
awplus(config)# ip igmp limit 25