Allied Telesis AT-9000 Series - Ip Igmp Snooping Mrouter

Chapter 26: IGMP Snooping Commands
484
IP IGMP SNOOPING MROUTER
Syntax
ip igmp snooping mrouter interface port
Parameter
port
Specifies a port connected to a multicast router. You can specify
more than one port.
Mode
Global Configuration mode
Description
Use this command to manually specify ports that are connected to
multicast routers. Manually specifying multicast router ports deactivates
auto-detect. To reactivate auto-detect, remove all static multicast router
ports. For instructions, refer to “NO IP IGMP SNOOPING MROUTER” on
page 487.
Confirmation Command
“SHOW IP IGMP SNOOPING” on page 488
Example
This example identifies ports 14 and 15 as multicast router ports:
awplus> enable
awplus# configure terminal
awplus(config)# ip igmp snooping mrouter interface
port1.0.14,port1.0.15