Allied Telesis AT-9000 Series - Ip Igmp Status

AT-9000 Switch Command Line User’s Guide
485
IP IGMP STATUS
Syntax
ip igmp status single | multiple
Parameters
single
Activates the single-host per port setting, which is used when the
ports on the switch have only one host node each.
multiple
Activates the multiple-host per port setting, which is used when the
ports have more than one host node.
Mode
Global Configuration mode
Description
Use this command to specify the IGMP host node topology. For
background information, refer to “Host Node Topology” on page 470.
Confirmation Command
“SHOW IP IGMP SNOOPING” on page 488
Examples
This example sets the host node topology to the single-host per port
setting:
awplus> enable
awplus# configure terminal
awplus(config)# ip igmp status single
This example sets the host node topology to the multiple-host per port
setting:
awplus> enable
awplus# configure terminal
awplus(config)# ip igmp status multiple