Allied Telesis AT-9000 Series - No Log Buffered

AT-9000 Switch Command Line User’s Guide
563
NO LOG BUFFERED
Syntax
no log buffered [level level ]|[program program ]|
[msgtext
msgtext ]
Parameters
level
Specifies the severity level setting.
program
Specifies the management software module setting. To specify
more than one module, separate the modules with commas.
msgtext
Specifies a text string setting.
Mode
Global Configuration mode
Description
Use this command to cancel the settings set by the log buffered
command. You can cancel a setting individually by specifying a parameter.
If you do not specify any parameters, the command cancels all the settings
and restores the default settings for the buffered log.
Confirmation Command
“SHOW LOG CONFIG” on page 568
Example
This example cancels the settings and restores the default settings for the
buffered log:
awplus# no log buffered
This example cancels only the setting of MAC and keeps other settings so
that the switch sends all messages that have a minimum severity level of 4
and that are generated by the IP program:
awplus# show log config