Allied Telesis AT-9000 Series - Show Etherchannel; Figure 111: SHOW ETHERCHANNEL Command

Chapter 41: LACP Commands
626
SHOW ETHERCHANNEL
Syntax
show etherchannel id_number
Parameters
id_number
Specifies the ID number of the aggregator.
Mode
Privileged Exec mode
Description
Use this command to display the ports of specific aggregators on the
switch. Figure 111 illustrates the information.
Figure 111. SHOW ETHERCHANNEL Command
Example
This example displays the ports of the aggregator with the ID number 22:
awplus# show etherchannel 22
Aggregator #2 .... po2
Admin Key: 0xff01 - Oper Key: 0x0101
Link: Port1.0.2 sync
Link: Port1.0.3 sync
Link: Port1.0.4 sync
Link: Port1.0.5 sync
Link: Port1.0.6 sync