Chapter 46: RSTP Commands
692
“SPANNING-TREE LINK-TYPE” on
page 705
Port Interface Designates point-to-point ports and
shared ports.
“SPANNING-TREE LOOP-GUARD”
on page 706
Port Interface Enables the BPDU loop-guard feature
on the ports.
“SPANNING-TREE MAX-AGE” on
page 707
Global
Configuration
Sets the maximum age parameter,
which defines how long bridge
protocol data units (BPDUs) are
stored by the switch before they are
deleted.
“SPANNING-TREE MODE RSTP” on
page 708
Global
Configuration
Designates RSTP as the active
spanning tree protocol on the switch.
“SPANNING-TREE PATH-COST” on
page 709
Port Interface Specifies the costs of the ports to the
root bridge.
“SPANNING-TREE PORTFAST” on
page 710
Port Interface Designates the ports as edge ports.
“SPANNING-TREE PORTFAST
BPDU-GUARD” on page 711
Port Interface Enables the BPDU guard feature on a
port.
“SPANNING-TREE PRIORITY (Bridge
Priority)” on page 712
Global
Configuration
Assigns the switch a priority number.
“SPANNING-TREE PRIORITY (Port
Priority)” on page 713
Port Interface Assigns priority values to the ports.
“SPANNING-TREE RSTP ENABLE”
on page 714
Global
Configuration
Enables RSTP on the switch.
Table 66. Rapid Spanning Tree Protocol Commands (Continued)
Command Mode Description
To Next Page
Loading...
