Chapter 46: RSTP Commands
696
NO SPANNING-TREE PORTFAST BPDU-GUARD
Syntax
no spanning-tree portfast bpdu-guard
Parameters
None
Mode
Port Interface mode
Description
Use this command to disable the BPDU guard feature on a port.
Edge ports disabled by the BPDU guard feature remain disabled
until you enable them with the management software. For
instructions, refer to “NO SHUTDOWN” on page 211.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 158
Example
This example disables the guard feature on port 4:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# no spanning-tree portfast bpdu-guard
To Next Page
Loading...
