AT-9000 Switch Command Line User’s Guide
697
NO SPANNING-TREE RSTP ENABLE
Syntax
no spanning-tree rstp enable
Parameters
None
Mode
Global Configuration mode
Description
Use this command to disable RSTP on the switch.
Before disabling the spanning tree protocol on the switch, display
the RSTP states of the ports and disconnect the network cables
from any ports that are in the discarding state. Ports that are in the
discarding state begin to forward traffic again when RSTP is
disabled. Leaving the cables connected may result in broadcast
storms from network loops. To view the states of the ports, refer to
“SHOW SPANNING-TREE” on page 698.
Confirmation Command
“SHOW SPANNING-TREE” on page 698
Example
This example disables RSTP on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# no spanning-tree rstp enable
To Next Page
Loading...
