Chapter 46: RSTP Commands
708
SPANNING-TREE MODE RSTP
Syntax
spanning-tree mode rstp
Parameters
None
Mode
Global Configuration mode
Description
Use this command to designate RSTP as the active spanning tree
protocol on the switch. After activating the protocol, you can enable or
disable the spanning tree protocol and set the switch or port parameters.
RSTP is active on the switch only after you have designated it as the
active spanning tree with this command and enabled it with “SPANNING-
TREE RSTP ENABLE” on page 714.
Only one spanning tree protocol— STP or RSTP— can be active on the
switch at a time.
Confirmation Command
“SHOW SPANNING-TREE” on page 698
Example
This example designates RSTP as the active spanning tree protocol on
the switch:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mode rstp
To Next Page
Loading...
