Chapter 48: MSTP Commands
738
Use the no command, NO INSTANCE MSTI-ID PRIORITY, to restore the
default priority value of 32768.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 158
Example
This example assigns MSTI ID 3 a priority of 4096 to port 4:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mode mstp
awplus(config)# spanning-tree mstp enable
awplus(config)# spanning-tree spanning-tree mst
configuration
awplus(config-mst)# interface port 1.0.4
awplus(config-mst)# instance 3 priority 4096
7 28672 15 61440
Table 70. MSTP Bridge Priority Value Increments (Continued)
Increment
Bridge
Priority
Increment
Bridge
Priority
To Next Page
Loading...
