Chapter 2: Starting a Management Session
74
Saving Your
Changes
To permanently save your changes in the active boot configuration file,
use the WRITE command in the Privileged Exec mode:
awplus# write
You can also update the active configuration file with the COPY
RUNNING-CONFIG STARTUP-CONFIG command, also located in the
Global Configuration mode. It is just more to type.
awplus(config-if)# switchport access vlan 5
Add the ports as untagged ports to the
VLAN with the SWITCHPORT ACCESS
VLAN command.
awplus(config-if)# exit
Return to the Global Configuration mode.
awplus(config)# interface vlan5
Use the INTERFACE VLAN command to
move to the VLAN Interface mode of
VLAN 5.
awplus(config-if)# ip address dhcp
Activate the DHCP client on the switch
with the IP ADDRESS DHCP command.
awplus(config-if)# end
Return to the Global Configuration mode.
awplus# show ip interface
Verify the management IP address on the
switch.
awplus# show ip route
Verify the new management IPv4 address
and default gateway.
Table 4. Adding a Management IP Address: Example 2
To Next Page
Loading...
