Chapter 48: MSTP Commands
754
SPANNING-TREE PATH-COST
Syntax
spanning-tree path-cost
path-cost
Parameters
path-cost
Specifies the cost of a port to the root bridge. The range is 1 to
200000000.
Mode
Port Interface mode
Description
Use this command to specify the cost of a port to the root bridge. This cost
is combined with the costs of the other ports in the path to the root bridge,
to determine the total path cost. For MSTP, this command only applies to
the path cost for CIST. The lower the numeric value, the higher the priority
of a path. The range is 1 to 200000000. The default depends on the port
speed.
To return a port to the default value, use the no version of this command,
NO SPANNING-TREE PATH-COST.
Confirmation Command
“SHOW SPANNING-TREE” on page 743
Example
This example assigns port 2 a port cost of 22:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# spanning-tree path-cost 22
To Next Page
Loading...
