Chapter 48: MSTP Commands
758
REVISION
Syntax
revision
<revision-number>
Parameters
revision-number
Specifies the revision number. The range is 0 to 255.
Mode
MST Configuration mode
Description
Use this command to specify the revision number of the current MST
configuration. This value is an arbitrary value that you assign to an MST
region. Use the revision number to track the number of times an MST
configuration has been updated on the network.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 158
“SHOW SPANNING-TREE” on page 743
Example
This example specifies the MST revision number as 4:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mst enable
awplus(config)# spanning-tree mst configuration
awplus (config-mst)# revision 4
To Next Page
Loading...
