Chapter 50: Port-based and Tagged VLAN Commands
786
NO SWITCHPORT ACCESS VLAN
Syntax
no switchport access vlan
Parameters
None
Mode
Port Interface mode
Description
Use this command to return untagged ports to the Default_VLAN.
You cannot return ports to the Default_VLAN if they are set to the
authenticator role for 802.1x port-based network access control. You
must first remove the authenticator role. For instructions, refer to
“NO DOT1X PORT-CONTROL” on page 994.
Confirmation Command
“SHOW VLAN” on page 790
Example
This example removes untagged port 5 from its current VLAN assignment
and returns it to the Default VLAN:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# no switchport access vlan
To Next Page
Loading...
