AT-9000 Switch Command Line User’s Guide
787
NO SWITCHPORT TRUNK
Syntax
no switchport trunk
Parameters
None
Mode
Port Interface mode
Description
Use this command to remove the trunk mode from ports. Ports cannot be
assigned as tagged ports to VLANs once the trunk mode has been
removed.
You must first remove a port from all tagged VLAN assignments
before you can remove its tagged designation. For instructions, refer
to “SWITCHPORT TRUNK ALLOWED VLAN” on page 797.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 158
Example
This example removes the trunk mode from ports 23 and 24:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.23-port1.0.24
awplus(config-if)# no switchport trunk
To Next Page
Loading...
