Allied Telesis AT-9000 Series User Manual

AT-9000 Switch Command Line User’s Guide
813
Enabling GIP on the Switch
The GARP Information Propagation (GIP) component can be enabled
separately from GVRP on the switch. GIP must be enabled if the switch is
using GVRP. The command for activating GIP is the GVRP APPLICANT
STATE ACTIVE command in the Global Configuration mode. Here is the
command:
awplus> enable
awplus# configure terminal
awplus(config)# gvrp applicant state active
For reference information, refer to “GVRP APPLICANT STATE ACTIVE”
on page 826.

Allied Telesis AT-9000 Series Specifications

General

Brand	Allied Telesis
Model	AT-9000 Series
Category	Switch
Language	English